Search results for "sodium acetate"
showing 10 items of 15 documents
Determination of water-soluble UV-filters in sunscreen sprays by liquid chromatography.
2002
Abstract Liquid chromatography was used for the determination of the three most used water-soluble UV filters, benzophenone-4 (BZ4), terephthalylidene dicamphor sulfonic acid (TDS), and phenylbenzimidazole sulphonic acid (PBS), in aqueous sunscreen sprays. A C 18 stationary phase and an isocratic mobile phase of EtOH–20 m M sodium acetate buffer of pH 4.6 (30:70, v/v) were used at a flow-rate of 0.5 ml min −1 . Mobile phase was also used as solvent for samples and standards. UV detection was at 313 nm. The analytical run took 5.5 min. The limits of detection were 0.5, 0.9 and 2 μg ml −1 for BZ4, TDS and PBS, respectively. The proposed method does not involve highly toxic solvents.
Production, crystallization and preliminary X-ray analysis of the human integrin alpha1 I domain.
1999
Integrin α1β1 is one of the main collagen receptors in many cell types. A fast large-scale production, purification and crystallization method for the integrin α1 I domain is reported here. The α1 I domain was crystallized using the vapour-diffusion method with a reservoir solution containing a mixture of PEG 4000, sodium acetate, glycerol and Tris–HCl buffer. The crystals beong to the C2 space group, with unit-cell parameters a = 74.5, b = 81.9, c = 37.3 Å, α = γ = 90.0, β = 90.8°. The crystals diffract to 2.0 Å and a 94.2% complete data set to 2.2 Å has been collected from a single crystal with an R merge of 5.8%.
Influence of the methodology of inoculation in the performance of air-breathing microbial fuel cells
2017
In this work, four air-breathing microbial fuel cells (AB-MFC) were operated for 1 month in order to determine if the methodology of inoculation affects the steady-state performance of this type of MFCs. For this purpose, anaerobic and aerobic sludge were fed to two identical AB-MFCs without any external carbon source into a tight sealed environment during the first three days of start-up. For comparison purposes, other two AB-MFCs were operated mixing the initial sludge and an amount of sodium acetate as substrate. Results point out that the inoculation procedure does not affect the steady-state treatment capacity of the cells but it affects very seriously the production of electricity. On…
Effectiveness of sodium acetate treatment on the mechanical properties and morphology of natural fiber-reinforced composites
2021
This paper aims to investigate the ability of an eco-friendly and cheap treatment based on sodium acetate solutions to improve the mechanical properties of flax fiber-reinforced composites. Flax fibers were treated for 5 days (i.e., 120 h) at 25 °C with mildly alkaline solutions at 5%, 10% and 20% weight content of the sodium salt. Quasi-static tensile and flexural tests, Charpy impact tests and dynamical mechanical thermal (DMTA) tests were carried out to evaluate the mechanical properties of the resulting composites. Fourier transform infrared analysis (FTIR) was used to evaluate the chemical modification on the fibers surface due to the proposed treatment, whereas scanning electron micro…
Dirhodium(II) compounds with bridging thienylphosphines: studies on reversible P,C/P,S coordination.
2009
Monocyclometalated compound [Rh(2){(C(8)H(4)S)P(C(8)H(5)S)(2)}(CH(3)CO(2)H)(2)(O(2)CCH(3))(3)] (1 a) and bis-cyclometalated compound [Rh(2){(C(8)H(4)S)P(C(8)H(5)S)(2)}(2)(CH(3)CO(2)H)(2)(O(2)CCH(3))(2)] (2 a) have been isolated from the reaction of dirhodium tetraacetate and tris(2-benzo[b]thienyl)phosphine (2 BTP) using low acidic solutions. By contrast, in pure acetic acid the reaction of Rh(2)(O(2)CCH(3))(4) with 2 BTP and tris(2-thienyl)phosphine (2 TP), followed by replacement of the axial acetate ligands by chlorides, led to [Rh(2){(2-C(8)H(5)S)P(2-C(8)H(5)S)(2)}(2)Cl(2)(O(2)CCH(3))(2)] (3 b) and [Rh(2){(2-C(4)H(3)S)P(C(4)H(3)S)(2)}(2)Cl(2)(O(2)CCH(3))(2)] (5 b), respectively. These n…
Isobaric Vapor−Liquid Equilibria for Water + Acetic Acid + Sodium Acetate
2003
Isobaric vapor−liquid equilibria for the binary water + sodium acetate and acetic acid + sodium acetate systems and ternary mixtures of water, acetic acid, and sodium acetate have been measured at 100 kPa with a recirculating still. The addition of sodium acetate to water + acetic acid mixtures produced an appreciable rise in equilibrium temperature but a small effect on the relative volatility of water, which was augmented at higher water solvent concentrations and decreased at lower concentrations. These effects increased with higher salt concentrations. The experimental binary data sets have been correlated using a modified Mock's electrolyte NRTL model, which takes into account the asso…
Expression, purification, crystallization and preliminary X-ray analysis of strictosidine glucosidase, an enzyme initiating biosynthetic pathways to …
2005
Abstract Strictosidine β- d -glucosidase, a plant enzyme initiating biosynthetic pathways to about 2000 monoterpenoid indole alkaloids with an extremely large number of various carbon skeletons, has been functionally expressed in Escherichia coli and purified to homogeneity in mg scale. Crystals suitable for X-ray analysis were found by robot-mediated screening. Using the hanging-drop technique, optimum conditions were 0.3 M ammonium sulfate, 0.1 M sodium acetate, pH 4.6 and PEG 4000 (10%) as precipitant buffer. The crystals of strictosidine glucosidase belong to the space group P 42 1 2 with unit cell dimensions of a =157.63, c =103.59 A and diffract X-rays to 2.48-A resolution.
An environmentally friendly (“green”) reversed-phase liquid chromatography method for UV filters determination in cosmetics
2005
Abstract A green procedure based on reversed-phase liquid chromatography with gradient elution using environmentally friendly solvents, has been developed to determine 18 UV filters, which are most used in Europe nowadays as sunscreen in cosmetics. Samples were weighed and dissolved in ethanol. Two aliquots were taken from the initial sample solution to prepare two solutions, so analytes could be determined chromatographically in two groups (the most fat-soluble and the easily water-soluble ones) using a different gradient elution program for each group. The mobile phases were based on mixtures of ethanol and 1% acetic acid or 1% sodium acetate buffer pH 4.75. The same C18 stationary phase …
Effect of a co-substrate supply in a MBR treating shipboard slop: Analysis of hydrocarbon removal, biomass activity and membrane fouling tendency
2018
The paper reports the main results of an experiment carried out on a membrane bioreactor (MBR) plant designed for the treatment of shipboard slops. With a view of a co-treatment process of the slop with other wastewaters, sodium acetate, as external co-substrate, was supplied (high dosage – Period 1, low dosage – Period 2) to evaluate its effects on hydrocarbons removal. The MBR pilot plant enabled approximately 99% of total petroleum hydrocarbon (TPH) removal during the entire experiment, confirming the robustness of the MBR technology for the treatment of slops. The chromatography/mass spectrometry analysis showed that the removal efficiency for each alkane was close to the value observed…
Biodegradation of Synthetic Organic Compounds by Methanogenic Microbiome as an Alternative Approach for Wastewater Purification and Energy Production
2022
The use of fossil fuels (methane, oil, etc.) is undergoing an unprecedented crisis now. There is the urgent need to search for alternative energy sources. A wide range of degraded organic materials can be effectively used to provide energy together with environmental protection. Soapstock is a hazardous waste containing a high concentration of toxic organic compounds of man-made origin (fatty acids, surfactants, dyes, etc.). To prevent environmental contamination such substances require an effective treatment approach. The goal of the study was to isolate the adapted-to-fatty-acids methanogenic microbiome and investigate the patterns of sodium acetate and soapstock degradation with simultan…